top of page
TABLE TYPE GLASS CUTTER
This unit is made so it can be clamped to a table or a work bench.
Glass tubing up to 1-1/2” diameter can be cut.
• Heavier Construction Throughout
• Large Round Cutter Shaft Knob
• Longer Gauge Glass Support
• Increased Opening For Clamping
to Work Surface
• New Wing Type Clamp Handle
MODEL EFI 734BC
MODEL EFI WC GLASS CUTTER
• Zinc Casting with Carbon Steel Wheel
• Cuts Up to 1” O.D. Glass Tube
• V-Shaped Cradle for Glass Placement
• Can Be Operated by Either Holding the Cutter or Placing
Cutter on a Flat Work Surface
• Comes with Its Own Storage Container
MODEL EFI WC
SQUEEZE & POP! GLASS CUTTER
VERSATILE - The same tool may be used on a variety of brittle tubular materials including gauge glass (all types), laboratory glass and porcelain tube.
ACCURATE - Cutter chain is wrapped around tubing right at the point where cut is to be made. Any length from 1/2” to several feet may be cut off.
CUTS UP TO 3/4” O.D.
MODEL EFI 734/690Q19
• Hardened Steel Cutter Wheel
• Cuts Up to 1-1/8” O.D. Tube
• Employs Two V-Guides for Tubing Alignment
• Coil Spring Action for Cutter Wheel Arm
MODEL EFI S-39955
GAUGE GLASS BRUSH
• Brush Lengths 24”, 30”, 36”, 42”, 48”, 72” for cleaning 3/8”, 5/8”, 1/2”, 3/4” or 1” O.D. gauge glass
A complete line of tools designed to handle your packing maintenance with ease. The unique interchangeablility of tips with flex or rigid holders allows a versatility not available elsewhere. Worn or damaged tips may be replaced at minimum cost rather than sacrificing the entire tool.
MODEL EFI PT-25
bottom of page